Search models, users, collections, and posts
Makita Track Saw Parallel Jig
IP Report
Print Profile(1)
0.08mm layer, 4 walls, 20% infill
4.4 h
1 plate
Open in Bambu Studio
Boost
163
578
8
11
157
75
Released
Bill of Materials
List other parts
- M3 X 8mm BHCS x 2: https://www.mcmaster.com/92095A181/
- M5 X 10mm BHCS x 8: https://www.mcmaster.com/92095A208/
- M3 Heat Set Inserts x 2: https://west3d.com/products/m3x4x5-threaded-heat-inserts?_pos=1&_psq=inserts&_ss=e&_v=1.0
- M5 Hex Nut x 4: https://www.mcmaster.com/90591A260/
- M5 X 16 Thumb Nut x 4: https://www.mcmaster.com/92581A350/
- M5 X 20 Thumb Nut x 4: https://www.mcmaster.com/92581A360/
- Misumi 2040 Extrusion x 2: https://us.misumi-ec.com/vona2/detail/110302684350/
- Adhesive Tape Measures x 2: https://www.mcmaster.com/1910A47/
Description
This is a jig to help make repeated parallel cuts with you track saw. Its designed for Makita tracks but should also work with Festool, and Powertec. It uses 40mm x 20mm extrusions, which gives a nice flat area for an adhesive tape measure to make setup easier. or setting up the tape, will need to take measurements with it setup on your track. Be sure to leave room to move the adjustment indicator in both directions for final adjustment. When sourcing 2040 extrusions, the length is based on how wide a cut you want to be able to set. You can order extrusions go about 125mm shorter then the cut you want to make.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)