High-Speed Fighter V2 (Articulated, No Hardware Required)

This is a Speeder V2 evolved from the Six-Wing Speeder, further reducing air resistance, flying faster during reconnaissance and surprise attacks, equipped with 4 small machine guns and 3 powerful engines. The only drawback is that its firepower is not as strong as the Six-Wing Speeder (I made this up (´▽｀) The wheels can rotate, and the 2 small wings on top of the cockpit can be opened by pressing them backward. If there are burrs on the edge of the cockpit cover, it will be harder to open. Small size LWH approx 97.8*70.5*35.3mm)

The base component and wheel component are 2-in-1 options for installation. If you don't need one of them, you can skip printing it via the mobile app, which will be faster

Note: It is recommended to print the wheel component using PETG. PLA is not smooth. The blue part in the GIF below is PETG, and the red is adhesive tape for easy observation. Overall installation is relatively simple. (Some force is required during installation)

Note:

1. Do not change the fuselage to print vertically, there is a chance of layer shifting between layers

2. Although not found in 5 print tests, but given the fear of wing collapse dominating 20+ times in previous large and small versions = = When the small size has not exceeded 112 layers (1.5 times 168 layers), please check a few times if the wings have collapsed

1. The image below shows the supports and brim that need to be removed (those indicated by red arrows, if you need to change the brim, you need to ungroup)

2. It is recommended to use scissors or flush cutters to remove supports and brim. Peeling by hand is also possible (a bit difficult) and not aesthetically pleasing. Pay attention to safety when using tools

The GIF below is the assembly diagram:

First, install the wheels (mind the direction, steps facing outwards, see image below) onto the bracket, then press on the fuselage

First generation Six-Wing Speeder: https://makerworld.com.cn/zh/models/1199387-liu-yi-ji-su-zhan-ji-ke-dong-wu-xu-wu-jin-jian#profileId-1273212

Note: 1. Both PLA and PETG can be printed. It's best to understand the characteristics of these two materials before printing to avoid printing failures!! For example, PLA can become brittle if left for a long time or at low temperatures, while PETG has good toughness. Please choose the filament that suits you!!

        2. If it's for younger children, and the parts are small and easy to disassemble, it's better to glue them firmly with 502 or other adhesives to prevent them from being swallowed!!

        3. If there are no special requirements, please do not use your own advanced process settings for printing~ to avoid printing failures!!

If your printd part has local spaghetti, or the filament doesn't stick to the build plate, please recall if you touched that area (hands secrete sweat and oil, touching it has a very high chance of causing spaghetti)  or if the build plate is dirty. The solution is to search online for how to clean a 3D print plate!! If other problems occur, please describe it in the comments section and add pictures, so it's easier for us to solve it~  Otherwise, I can't imagine the situation = =!!