Party Maze challenge

Say bye to boring afternoons with this amazing maze game!

This will not only challenge your solving capabilities but also your collaboration and coordination skills with other people.

It consists of a game for two people, where the objective is to take the marble from the initial point to out of the board but you must do it by pulling the corners through a rope to tilt the board and take it through the entire route.

Once you achieve it, you can increase the difficulty by changing one of the ropes and pulling in a cross, or trying to do it in the shortest possible time.

I have designed this for a 6mm ball bearing, and the max build volume of an ender 3 or similar. so you will be able to print it in almost any printer

I´ve made 2 levels:

• level 0 = easy to achieve, with little travel. to familiarize yourself and learn
• level 1 = with more travel and possible paths. ideal to compete and improve

and I'm working on an even more difficult one, let me know if you'd like it.

every level starst at the circular wall (there is only one in each), and you have to take the marble to the path until it leaves the board.

if you achieve both levels you can use them in other ways, for example starting at each of the corners and taking the marble to the official start or official exit. doing so they practically become 3 versions each

you will need:

Printed parts

1 - game board

4 - poles

1 - maze of any level you want

Not printed parts

4 - rope sections of 30cm each (you can use whatever rope you have on hand, from a shoestring to paracord. just make sure you don't use fishing line and pretty much anything can work)

1- hot glue gun, 3D gloop, or any glue of your choice for pla or printed material

to assembly you just need to glue the poles to the board, and then pass the rope through them to tie the maze at the other end. you can check the pdf for more datailed instructions.

Print Settings

Material: PLA / PETG

Layer height: 0,28 mm for board and holders. 0.2 for maze

Nozzle diameter: 0,4mm or 0,6mm

Infill: 12-15%

Perimeters: 2

Support: no

if you want a multi color maze just insert a filament change at: 1mm

you can check all my other designs here

dgoalva | Printables.com