Search models, users, collections, and posts
AR15 Magazine Pouch Inserts (for Warrior LPC)
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
6.7 h
2 plates
Open in Bambu Studio
Boost
47
91
0
0
80
34
Released
Description
My warrior LPC came with rubber+string retention so I took a kydex insert from a different pouch and modelled it in fusion.
- Width: 65mm
- Screw hole at the bottom (4mm diameter..i think.)
- recommended material: PETG (didn't try any others but in PETG it is surprisingly sturdy and springy.
- print on the SIDE (otherwise it'll be super brittle)
- might not fit canvas-only M4 pouches - try printing it less wide and lemme know / add print profile ;)
- Not too crazy print time
I might add the fusion file if it's requested a lot
..This is my first original design and post so be gentle.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)