Search models, users, collections, and posts
xTool F1 - Leather Key Tag Jig
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
34 min
1 plate
Open in Bambu Studio
Boost
15
28
0
0
27
23
Released
Description
A helpful little jig to align leather key tags on the xTool F1.
I've used it for keytags like this. The “fingers” on top of the leather help to hold it down flat while providing as much engrave-able space as possible.
Designed to work with a keychain with the following dimensions:
- Leather thickness: 1.5mm
- “Inner length”: 84mm (the length inside the loop - this is the length of the tab that sticks out of the jig)
- Tag width: 15.5mm
Uses the m3 thumb screws that came with the F1 - just thread them through the holes in the jig (I use the ones farthest away from the center, so they don't overlap the leather at all), and they should thread right into the holes in the removable baseplate.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)