Back support (AMS Lite A1 Top Mount)

Back support (AMS Lite A1 Top Mount - No Tilt)

This is a back support for the A1 printer that uses the AMS Lite A1 Top Mount - No Tilt Remix. The top mount can be found here:

https://makerworld.com/en/models/707336-ams-lite-a1-top-mount-no-tilt-remix#profileId-637387

The no tilt remix shifts the center of mass a bit to the back. It means that there is a chance that the printer could wobble which could affect the prints quality. This is why I designed this back support. It's designed to perfectly fit at the backside of the printer. The support raises the printer slightly and provides a lot more stability (You can test it by trying to tilt the printer backwards). 

For me this model works as is. It doesn't move and it provides more stability. I was thinking of using double sided tape to tape it to the printer and using rubber pads on the bottom of the support, however, it doesn't seem like it's necessary. If you happen to have problems with it moving then consider taping it to the printer and adding rubber pads underneath.

Hope this helps! 👍

🔥 Enjoying my work? Please boost, like and follow! Your support is a big help! 🔥

If you'd like to provide more support then you can buy me a coffee here - ☕ https://buymeacoffee.com/krystocraft Thank you! ❤️