Rocoren 480 W USB C Charger Under Desk Mount

I needed somewhere to hold my Rocoren USB Charger, which was not on my desk, and where it would be secure. I therefore created this model, which is in 2 parts to safely hold the USB charger under my desk. It can be secured either with screws or with sticky pads. 

The item is in 2 parts

1. The main body that holds the USB charger

2. The plate that sits on top of it to keep it secure and form a single colour border around it. Printing it separately means there is no need for supports and you get a nice finish. 

To hold the charger firmly so you do not have to over tighten the screws, I placed a small double sided sticky foam pad between the top plate and the USB charger, and now the solution does not move at all when plugging in and taking out the cables. 

This was printed on an X1C with PLA, with a print time of 1hr 59m, with Prep time of 7mins 20 sec included. It uses approximately 90.96g of filament (30m)

The specific charger this relates to is this - https://www.amazon.de/-/en/dp/B0DK1C14HM?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_9

The link is for information purposes only, I do not receive any benefits if you do wish to purchase it.