Flower plant support - adjustable

Adjustable plant support, for 8.7 mm diameter rods. The rod clamp is designed to be partly self-locking. To mount it, always extend the clamp and position it as required (it can be positioned in any arbitrary position on the rod). The center piece is designed to mount up to 6 rods (I have prepared 6 slots). It is therefore possible to use 3 rods as a base and use the other rods to create, for example, an additional tier of plant support. Alternatively, the empty slots can be used to connect to another central support part and thus build a large system for growing plants and so on.

the pivots allow the bars to be adjusted for tall plants, but also for wide plants - the possibilities are many

the plant is supported by the support bars. The centre circle is only for saving material when printing.

For the connection of the rod clamp and the center part, some bolt and nut are needed (the diameter of the prepared hole is 5mm). Due to the partial self-locking nature of the clamp, it is possible that even a tightening or tying tape will be sufficient for attachment

for printing parts I recommend to use PETG