Search models, users, collections, and posts
Negative Busbar
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 20% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
19
67
4
4
54
23
Released
Description
Content has been automatically translated.
The Busbar features four holes, into which two M8x30 bolts (stainless steel recommended, Amazon link: https://shorturl.at/4hSSs) and two M8x17 bolts (stainless steel recommended, Amazon link: https://shorturl.at/bRPoA) must be inserted. The two longer M8x30 bolts extend beyond the Busbar's protective cover, securing it with two plastic blind nuts, Amazon link: https://shorturl.at/pGcJB. The Busbar base can be attached to a wooden panel using two 4x25 countersunk screws. For printing this project, I recommend PETG, as the currents involved can sometimes slightly overheat the bolts where the crimped lugs are attached to the cables, but a good PLA+ will also suffice.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (4)