Search models, users, collections, and posts
Height-Adjustable Garden Table
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
54 min
1 plate
Open in Bambu Studio
Boost
4
15
10
2
16
8
Released
Description
Content has been automatically translated.
Preliminary information:
I am completely new to 3D printing
The model is not 100% aligned!
I had to post-process the screw so that it could be screwed in smoothly.
The screw can be scaled down slightly during printing for a better fit in the thread.
-----------------------------------------------
I wanted to print a new foot for our garden table, which has almost horizontal legs, because it always wobbled.
The foot can be used for pipes that are 30mm wide.
I printed both parts in PLA. PETG might also make sense due to weather conditions, however.
-----------------------------------------------
I welcome any tips to improve my future designs!
But perhaps it will help one or the other.
Looking forward to your feedback!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (10)