Ring Indoor Camera 2.Gen Holder - Free 3D Print Model

Search models, users, collections, and posts

mextabo

Hobby & DIY>Other Hobby & DIY

IP Report

Print Profile(1)

All

H2D

P1P

A1 mini

X1 Carbon

X1E

P1S

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 20% infill

Designer

58 min

1 plate

4.7(15)

Open in Bambu Studio

Boost

216

253

233

Released

Description

Content has been automatically translated.

Show original

A mount for the Ring Indoor Camera 2nd generation, enabling flexible camera positioning without permanent attachment

Hope it fits :-)

Comments are welcome

Comment & Rating (25)

@dfreshkremer

Print Profile

0.2mm layer, 2 walls, 20% infill

printed in PLA with PETG supports. worked perfectly. thanks.

The profile uploader has replied

@mextabo

super, vielen Dank

@MARZ77

Print Profile

0.2mm layer, 2 walls, 20% infill

I’m giving 5 stars because it did print well and I might have had to change some settings.

The profile uploader has replied

@mextabo

Thank you (:

Show original

@DRENTIKCUS

Print Profile

0.2mm layer, 2 walls, 20% infill

modified to use 10x3 magnets, print had no issues.

The profile uploader has replied

@mextabo

super good idea 👍🏻 thank you for your review and improvement of the holder :)

Show original

@Chr15pyONE

Print Profile

0.2mm layer, 2 walls, 20% infill

Before I write anything: 4.5 stars b it can’t give that hence 4. Works VERY well but…it is a real pain to remove the small supports that are used. Sure…a set of needle nose pliers do remove it fairly well but it was annoying that I needed to use them to make it work.

The profile uploader has replied

@mextabo

Thank you for the rating. That's right, it's a bit tedious to remove the supports.. there was no other way. It might work to place the object upright on the plate and try printing it. Thank you

Show original