Monstera Leaf Set

Designed by an 14th years old

Monstera Leaf Set:

An Leafset for decoration!

Use it as an earring, keychain, or just print them to have fun.

Attach a Keychain on the printed Leaf and you'll have a nice, good looking, green leaf on your keys.

Tip for Girls: (print them and use it as an earring)

The picture's above are the leafs but without the hole were the keychain will be attached to. But the size is the same.

The leafs are about 5cm long (2inch)

Printing settings:

Bambulab 0,12mm High Quality Setting for your 0,4mm Nozzle.

But for better results: 0.08mm High Quality Setting for your 0,2mm Nozzle

1.Print Profile (0,4mm Nozzle): It's the leaf with a thin thickness (See last Picture)

2.Print Profile (0,2mm Nozzle): It's the same as the first Print Profile but with 0,2mm Nozzle

3.Print Profile (0,2mm Nozzle): Thicker leafs. This is the print setting which I normally use (Rest of the pictures)

4.Print Profile (0,4mm Nozzle): Same as the 3. Print Profile but with 0,4mm Nozzle.

I would recommend to print the leafs with a 0,2mm Nozzle (If you own one) not depending which thickness you choose.

Printed in green PLA from Bambulab.

Design by David