CH-54 Tarhe "Skycrane" Helicopter Coasters

CH-52 Tarhe “Skycrane” Helicopter Coasters

These helicopters were made by Sikorsky Aircraft company. The CH-52 Tarhe served a multitude of uses in Vietnam.
 

These coasters are 100mm in diameter and 3mm thick.

I printed these on my Bambu X1C. I used an initial layer line width of 0.3 instead of the usual 0.5 because of the small lines. If you have issue printing with a 0.3 line setting I would suggest spraying a little bit of Aqua-Net hair spray on the plate.

I use these 4 x 4 Inch round self adhesive cork backing from Amazon. I have provided the link to them. https://a.co/d/aAasVK4
If these are out of stock almost any adhesive cork backing will work as long as its 100mm in diameter and I prefer ones that are 1mm thick. You may have to trim them to fit neatly.

If you like railroad and non-railroad coasters and clocks, take a look at my other coasters and clocks at https://makerworld.com/en/@railimages