Search models, users, collections, and posts
Polaris flag washer U-shaped washer flag holder
IP Report
Print Profile(1)
0.16mm layer, 6 walls, 15% infill
Designer
17 min
1 plate
Open in Bambu Studio
Boost
2
4
1
0
13
5
Released
Description
Content has been automatically translated.
JPG Design3D
Washer for the flag holder found on various Polaris models.
The original holder has a rather large hole.
This washer is designed to adapt to smaller screws.
Print with 10+ perimeters and drill the hole to the size you need.
Inner diameter: 8.1mm
Outer diameter: 27.75mm
U-shaped washer for the flag holder on various Polaris models.
The original holder has a relatively large bore.
This U-washer is intended to adapt to smaller screws.
Print with at least 10 perimeters and subsequently drill to the required size.
Inner diameter: 8.1mm
Outer diameter: 27.75mm
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)