Swing Storage Ornament

【Boots Creation】

Thanks for the likes

Swing storage ornament, the hamster shown in the picture is a dwarf hamster

Printing Notes:

1 The plate layout in the file has been tested, combining printing strength and aesthetics, making your own changes may result in unsatisfactory print quality

2 Prepare small pliers, when removing the main swing supports, small pliers are needed to snip off the wrapped supports

3 Prepare glue, this model has fine details, tearing may inevitably occur during printing, a slight repair will suffice

4 Prepare a utility knife to trim edges and corners

5 Current printing test: The pictures show successful prints with Bambu Lab PLA Basic Gold and Bambu Lab PLA Matte Scarlet, I previously tried printing several times with Dian Wei filament and all attempts failed, so printing with other filaments may result in print failures, you can try it yourself

6 The pictures show slightly fewer imperfections on the right side, if you want it on the left side, swap the top and bottom of the standing support rod

For more hamster hideouts and supplies, see→Hamster Supplies Collection

Support Removal Tutorial:

(1/4) First, remove the two large supports in the middle

(2/4) Use pliers to snip off and then remove the two external supports

(3/4) Use pliers to snip off and then remove the small internal supports

(4/4) Remove the remaining external supports, done

Unless otherwise stated above, I use the "stabilized low-temperature print plate" for printing.

If there are printing problems, you can comment below with pictures to solve the problem together

-----------------------------------------------------------------------------------------------------------------------