Clip-On Slide Badge Holder for Your “Make-My-Sign”

Turn every personalized sign into instant, wearable flair!
This two-part Clip-Card Badge Holder is precision-matched to the blank plate included on this page (credit-card size 85.60 × 53.98 mm, 1 mm thick, 5mm corner radius). Just print the holder, press Customize, and Make-My-Sign opens with the ready-sized plate—draw, print, and slide it in. No glue, no screws, just click-n-clip.

• Tailor-made fit – rails are tuned for this plate’s exact dimensions; 1 mm stock slides in with satisfying friction.
• Clothes-friendly clip – rounded jaw hug fabric without snagging; strong enough for jackets, gentle enough for T-shirts.
• Light, one-part supports – only the holder body needs minimal auto-supports; they pop off in seconds. The clip arm prints totally support-free.
• Color-play ready – pair the plate with multicolour AMS prints or run the holder in a contrasting filament.

Print Tips

• Holder-Body - 0.16 mm layer height, supports enabled (normal, auto)
• Clip-Arm - 0.16, no supports required
• Filament: PLA

Weight: ~ 12 g in total; ±30 min on a Bambu Lab A1 mini.

How to Use

1. Print both parts (holder supports flick off—no sanding needed).
2. Snap the clip arm into the hinge pocket until it clicks.
3. Customize → your blank plate opens in Make-My-Sign → add artwork → print.
4. Slide the finished plate into the rails until flush.
5. Clip-on and show off your creation!

If you remix or resize, link back here so others can discover the original.
Enjoy—and don’t forget to post your make & boost if this holder keeps your sign shining!