Search models, users, collections, and posts
Auto Filament level indicator
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
43 min
2 plates
0.16mm layer, 2 walls, 15% infill
56 min
2 plates
Open in Bambu Studio
Boost
153
314
4
9
172
64
Released
Description
This is Auto Filament level indicator that use a plastic spring to indicate amount of left filament.
- Set minimum layer time to close to 10s while printing front lever
- Both front and back lever have to be glued in place as shown in 3rd picture
- Both lever must be perfectly aligned/parallel to each other
- then device can be mounted on spool with tissue tape or double sided tape
NOTE :- This model is based on Numakers spool dimensions there could be minor inaccuracy in measurement for other brands
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (4)