Search models, users, collections, and posts
Chain Oiler - Oil line mount for Honda CBF600
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
51 min
1 plate
Open in Bambu Studio
Boost
5
11
0
0
6
0
Released
Description
Here comes a very niche design!
This is an oil line mount I developed to better guide the oil line of the DIY chain oiler (Reh-Oiler Project) used on my Honda CBF600 (PC38)
It should fit any box swingarm with a width of 35mm however.
It is mounted with a cable strap to the underside of the swingarm. A 5mm brake tube can be fed through the wholes.
There are 2 hex shaped openings at the top to accept a M3 lock nut each. This allows to fix the brake tube in place with two M3x12mm screws from below the swingarm after everything is installed.
I pinched the brake tube with some pliers until the orifice was super tiny to replace a cannula I had installed prior to this mod.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)