Bracket for Luminte Graviton M1+Behringer P16-MB

This bracket snaps onto the Graviton M1 and then slides onto the P16-MB which is attached to a mic stand. This is a functional print and not in any way well designed. I needed a solution that was better than taping my M1 to a p16-mb at each gig so i hacked this together in Bambu Studio. it works perfectly, but can be better designed and look nicer too, feel free to make it better.
Gotchas: If you use the 5-pin midi ports on the side of the M1 (I do not) this clip covers them over entirely, and you could in theory pop this into Bambu Studio and add a couple negative cylinders to punch holes in the side for the midi plugs. This prints in about 40 mins on the X1C and uses about 20g of PLA.