Churu Popsicle for Cats (No supports needed)
Print Profile(1)
Description
Make treat time extra fun with this 3D printable Churu popsicle mold! Designed to fit standard Churu tubes, this mold transforms your cat’s favorite puree into a cool, long-lasting snack. The two-part mold clicks together for easy freezing and features a built-in textured stick and a stable base to keep it upright.
Features:
- Fits standard Churu and similar treat tubes
- Two-piece design for easy fill and release
- Textured stick for grip
- Wide base for freezer stability
- Reusable and easy to clean
Instructions for Use:
- Fill each half with Churu or another soft puree treat
- Snap the mold together and freeze
- To release, run the mold under warm water for a few seconds
- Serve and let your cat enjoy a frozen treat!
Print Settings:
- Layer Height: 0.4 mm
- Infill: 15%
- Supports: Not needed
- Material: PLA or PETG (use food-safe filament)
- Orientation: Print upright as shown in the image
Tips:
- Hand wash only unless using high-temp filament
- Optional: Use a rubber band or small clip to keep the mold tightly closed while freezing
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)