DareDevil Born Again Billy Clubs (Functional)

DareDevil Born Again Billy Clubs Fully Functional

Items you will need for the build 8x2mm Magnets, 5 in total. 1 for the End cap and 4 for the Wire weight.

A 12+ inch wire or string.  The plus is so you have enough slack to tie the knots. From knot to knot should be 12 inches.

Use the End Cap that has a cut out for a 8x2 mm magnet. 

You can also use a rubber band instead of magnets. You will want a rubber band that can stretch the entirety of the handle.

For this you will need a 10+ inch string or wire. The plus is so you have enough slack to tie the knots. From knot to knot should be 10 inches.

Use the End Cap that has the half circle. 

You do not need both Rubber band and magnets. 

If you choose the Magnet option then the rubber band End cap will go on the single Stick that has no function and vice versa if you use the Rubber band, The magnet End cap will go on the single nonfunctional stick. 

This is so you didn't need to print unnecessary items to only through away. 

Each side of the clubs screw in at opposite directions. So one side will screw in counter clock wise and the other clock wise.

Please do a dry test fit to ensure you do not mix the directions. I added a picture to better show what I'm referring to. 

Why the two different ways to attach the string ?    I didn't like that when using the rubber band you couldn't display the clubs in their nun chuck form, as the rubber band is constantly trying to close the two parts. This is great at a con or what not but not great for display. 

Please do test fittings before gluing any of the parts together, it is 100% necessary if you don't want any headaches.

Enjoy