Search models, users, collections, and posts
E14 Lamp Shade / Replacement Glass for Tea Light Holder
IP Report
This model is created by Make My Vase
Make Your Model
Print Profile(1)
0.16mm layer, 1 walls, 0% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
36
89
20
2
154
90
Released
Description
Content has been automatically translated.
A glass lampshade on my 5-light ceiling fixture, an E14 lamp, broke.
Since there was no suitable replacement with the same dimensions, I quickly designed a replacement myself.
Depending on the size, it can also be well used as a tea light holder (but then better not made of PLA).
Diameter of the hole at the E14 socket: 28mm
Outer hole diameter: 60mm
Lamp shade diameter: 98mm
Lamp shade height: 92mm
The following settings have proven suitable for me:
- printed in Spiral Vase mode: Best light transmission with 1 outer wall, seam not visible
- for stability, the outer wall in 0.55mm (with 0.42mm the lampshade is quite unstable)
- Layer height 0.16mm (0.20mm also possible, but looks a bit coarser when backlit)
- no supports needed
- Test printed in PLA, so far I have had no problems with 5W LED lights regarding temperature, deformation etc.
Boost Me (for free)
Feel free to give me a boost if you liked the model!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (20)