MTB Mud Guard / Mudguard Seat / Fender

check out my new bike stuff organizer :

https://makerworld.com/de/models/2747197-mtb-accessories-wall-mount#profileId-3047351

Hello, to protect myself a bit from dirt and moisture in the new mountain bike season, I printed this mudguard. It's super easy to attach in seconds without cable ties and holds really well. Since it's very thin, it can also be perfectly stored in a backpack and only attached when needed. After printing, you should place the mudguard in the middle on an edge and warm it slightly with a hairdryer to shape it a bit. The pictures show how to attach it under the saddle. The first installation is a bit difficult, but once you get the hang of it, it's super easy. It fits great on my saddle; I hope it does for you too. I wish you a lot of fun with it :)

Please let me know in the comments how it fits for you, preferably with a picture

Hello, To protect myself a little from the dirt and moisture in the new mountain bike season I printed this mudguard. It is super easy to attach without cable ties in seconds and holds really well. Since it is very thin, it can also be stored perfectly in the backpack and only attached when necessary. After printing, you should place the mudguard in the centre on an edge and warm it up a little with the hair dryer so that you can shape it a little. On the pictures you can see how to attach it under the saddle, the first assembly is still a bit difficult but when you get the hang of it, it's super easy. It fits great on my saddle I hope with you too, I wish you a lot of fun with it :)

Please let me know in the comments how it suits you, gladly also with a picture

-------------------------------------------------------------------------------------------------------------------------------------------------------------

Please note that the quality and successful printing always depend on the material used for my models and print profiles! I use Highspeed PLA+ for all prints