Search models, users, collections, and posts
HONDA CBF125 brake lever
IP Report
Print Profile(1)
0.2mm layer, 14 walls, 15% infill
Designer
56 min
1 plate
Open in Bambu Studio
Boost
23
37
3
2
66
23
Released
Description
This was made as a small test of my design abilites and as for emergency use only. Plastic should not be used to replace any metal part on a vehicle. However i have printed this in petg-cf and it works fine albeit more flexible than the original metal part and producing less braking force. if you decide to use this on a bike then it should be printed in the strongest plastic you have, ideally abs or stronger. Warning this should not be used as a permanent replacement for the metal lever.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (3)