Druckknopf

Adhesion issues are not a model flaw, but a matter of settings. I printed it in PETG on the high-temperature bed multiple times without problems. You could add a brim if necessary. However, for future reference, please do not give models poor ratings due to incorrect slicing or printing settings. It is unfair to hold the creator responsible for your own mistakes 😉

If the part isn't sticking to the print bed, it's not the model's fault. Please clean your print bed, use glue, or check your settings.

With brim it was sticking. I clean my bed every time. it lost it in the middle - probably on the thickening of the male model, whatever. But, nice to see you there stubborn defending. Whatever.

additionally - it breaks very, very easy - yes with PETG.

what filament did you use? The print is designed for PETG, PLA is unfortunately too brittle

Oh... that clears it up! My bad. Sorry!

it would be nice if you would revise your review then

 I have modified the file a bit to make it more stable. I would be happy if you gave it another chance.