Plague Hunter

I wanted to create a character that combined two of my favorite archetypes: the plague doctor and the witch hunter. So, I merged them into one, and this is what came out of it, which I am very happy with.
I wanted to see if I could generate some acceptable drawings with IA to later convert them into Hueforge plates, and I actually managed to get a few. This is one of them, and you can find more on my profile.

Project: Cazador de la Peste.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.3mm

Filaments Used:
    PLA Smartfill Black 
    PLA BambuLab Basic Blue Gray 
    PLA Smartfill Grey
    PLA Smartfill White 
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #8 (0.72mm) swap to Blue Gray
    At layer #13 (1.12mm) swap to Grey
    At layer #20 (1.68mm) swap to White for the rest.