Dewalt Jigsaw holder for Multiboard

I needed a holder for my Dewalt jigsaw (DCS335) on Multiboard. Other holders I have seen hold the jigsaw by its shoe and its center of mass is high up, so they might break over time. So I created two "hooks" that put the weight closer to the Multiboard tile(s) and holds the jigsaw firmly.

The holders are using Heavy Weight-Bearing Hook Snap and bolt locking with Multipoint to make sure it is firmly secured to the Multiboard tiles.

You need the following snaps/Multipoint to use the holder:

• 2 pcs - Heavy Weight-Bearing Hook Snap (1 for each holder)
• 2 pcs - Moderate Weight-Bearing Snap (1 for each holder)
• 4 pcs - Small Thread - Multipoint (2 for each holder)

I have also created a holder for the jig saw dust chute, check it out if you need it.

The Multiboard is created by Jonathan from Keep Making - https://www.multiboard.io/