3Ddy

cover

Untitled.png

plate_1.png

2025-04-20_87975065c50f3.jpg

0.16mm layer height, prints without support

0.16mm layer, 2 walls, 15% infill

Peckinpaw

IMG_1061.jpg

IMG_1060.jpg

<ul><li>.016 Layer Height</li><li>100% Rectilinear infill for weight and strength</li><li>4 wall loops for extra rigidity</li></ul>I created this print profile to add extra weight and rigidity so it would accommodate some flower models, such as the sunflower shown here, that are a little top heavy and prone to tipping the stand over.&nbsp;Note: The designer&#39;s original profile uses about 52g of filament and weighs about 50g with 15% infill. This profile uses 156.97g of filament and weighs about 155.1g&nbsp;The photo shows a print I made with Bambu Lab Translucent Blue PETG, along with the sunflower at https://makerworld.com/en/models/1036957-sunflower-by-clemix#profileId-1020968

0.16mm layer, 4 walls, 100% infill for weight

I needed a stable stand for this very nice rose <a target="_blank" rel="noopener noreferrer ugc" href="https://makerworld.com/en/models/988983-rose-flower#profileId-964201.">https://makerworld.com/en/models/988983-rose-flower#profileId-964201.</a>  The ones I found were not stable enough.

Heart shaped flower stand

ASIA

Print Profile(2)

Description

Comment & Rating (42)

License

Related Models