BMW Cradle

This is the part that locks the phone in the cradle, since the original part broke for several friends, I created a more stable version, now after several improvements I would like to share it with you.(Use at your own risk, of course, I assume no liability) I printed it with 100% infill, 0.12 layer height with a 0.4 nozzle on the A1 mini in PETG, if you can use ASA or CF you should try it, I can only say that it is very strong with PETG, I would advise against PLA as it breaks faster - I printed some parts and tried to break them, PLA is not recommended.

However, some post-processing is required to remove the supports cleanly. The lip is made of TPU and must be attached with strong adhesive, I hope you can see the small groove in the pictures where the lip is guided.