Heated Fan Modification for Active Chamber Temperature Control_Modified Housing - Free 3D Print Model

Search models, users, collections, and posts

墨乄淵

3D Printer>3D Printer Accessories

IP Report

Print Profile(1)

All

Voron Trident 300

0.2mm layer, 3 walls, 10% infill

Designer

7 h

1 plate

Open in Bambu Studio

Boost

Released

Description

Content has been automatically translated.

Show original

This model is a simple housing based on the illustrated heater, retaining the PTC, thermostat, and fan

The PTC measures approximately 66x75mm, and the fan measures approximately 92x92mm

Since the heater is 1.2kW, it is recommended to configure separate connections for the PTC and fan, limiting the PTC current to reduce power

Requires 4-13 3x4x5mm heat-set nuts and several M3 screws

Four screws are required to secure the fan; others are optional: two for side mounting, four for airflow direction, and one for thermostat mounting (omit if using the heater's built-in thermostat)

The airflow director is optional, and its effectiveness is untested; This model was designed using Trident and OrcaSlicer; configurations are for reference only, no supports are needed, and a 50°C bed temperature is recommended for ABS

https://blog.moyuan.eu.org/archives/zhudongcangwen

Cabin Temperature

Active enclosure temperature control

Printer MOD