Double Vertical Laptop Stand
Print Profile(1)
Description
Check out my single laptop stand of the same style:
https://makerworld.com/en/models/1624837-single-vertical-laptop-stand#profileId-1715485
Double vertical laptop stand, specifically designed for an M1 Macbook air, and a 2024 Zephyrus G14. But it of course will fit laptops of similar sizes. The larger gap is 20.75 mm, and the smaller gap is 17 mm. If you need a little more or less room, scaling the pieces up and down shouldn't be an issue.
I didn't use supports, but make sure your bridging settings are adequate for larger gaps. Or just enable supports.
I also designed slots to insert TPU strips that have a slightly higher z height than the base, where the laptops rest. This just gives them a bit of cushion and grip. These will just snap into place. Same with the feet, TPU feet should just snap into place. I did not use glue for any of the TPU pieces.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (29)