Search models, users, collections, and posts
Centauri Carbon PTFE Cable Chain Tube Support
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
27 min
1 plate
Open in Bambu Studio
Boost
33
99
4
2
168
30
Released
Description
Content has been automatically translated.
On the Centauri Carbon, I noticed that the PTFE tube bent too much above the print head and the filament struggled to pass through. I created (following the idea of Moto Mongrel on the Facebook group “Centauri Carbon Official User Group”) a clip that attaches to the cable chain and holds the PTFE tube slightly higher, allowing for a wider curve of the tube.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (4)