Guitar Wall Hanger

This is my exclusive to Makerworld Guitar Wall Hanger

This is a new design that features holes in the mounting prongs. With a sharper/angular design, it gives it a whole new look compared to my previous designs. 

The wall hanger is suitable for many instruments, including Bass guitar, Acoustic Guitar, Ukulele, and more. 

Though the design works for non-symmetric headstocks, it best suits symmetrical headstocks that allow the guitar to hang straight.

You can even hang a skateboard.

OTHER SELF LEVEL DESIGN CLICK HERE https://makerworld.com/en/models/2738348-self-level-guitar-wall-mount#profileId-3036188

2 OPTIONS. ONE HANGER HAS A 5MM OFFSET THAT HELPS WITH ACOUSTICS. IF YOU REQUIRE I LARGER OFFSET, PLEASE MESSAGE ME. I WILL SORT YOU OUT. 

PRINT SETTINGS

 - 3 WALL

 - 15% GYROID INFIL OR TRIANGULAR

 - PRINT BRACKET LAYING DOWN

 - PRINT MAIN BODY UPRIGHT 

 - TREE SUPPORTS JUST FOR THE OVERHANG OF PRONGS

 - LAYER HEIGHT TO BE 0.1-0.2mm

 - 0.1MM FIRST LAYER HEIGHT (DEPENDS ON PRINTER)

ASSEMBLY

 - USE M4 OR ABOVE SCREWS. APPROX 40MM OR MORE IN LENGTH

 - MARK AND ALIGN THE BACK BRACKET TO THE WALL AND MARK THE HOLES

 - EASIER TO DO THE FIRST ONE, SCREW IN THE TOP HOLE, THEN VERTIALLY ALIGN THE LOWER SCREW HOLE AND

DRILL THAT HOLE. 

 - JUST SLOT FROM HANGER OVER BRACKET.

WARNINGS

• PLEASE USE SUITABLE WALL FIXINGS. MINE HUNG FOR OVER A YEAR USING THE FIXINGS MENTIONED ABOVE.
• PLEASE USE A MINIMUM OF 3-4 WALLS ON YOUR DESIGN
• TEST THE STRENGTH OF PRINT TO MAKE SURE YOUR LAYER ADHESION WAS ADEQUATE

Thank you for viewing and downloading my creations. I really appreciate all the positive feedback you guys on MakerWorld give. Take care, and keep printing!
Dan @ DT3D_PRINT