OpenRack – Dell OptiPlex Micro - No Supports Remix

Remixed @JeffHiggins' Optiplex Micro holder for the OpenRack system. Should fit most if not all of the Optiplex Micro SFF computers. I modified the rear lip to make it angled, I also arched the feet slots slightly. The lip on the original model was intended to keep the computer from sliding out the back, but I found that the feet slots and angle were enough. Also when other equipment is racked above, this becomes a non-issue. With my changes, the model can now be printed supportless, saving both time and filament. 

I had some trouble with my print quality which I think is tied to my ancient and low quality roll of Black PETG. It's functional anyways, and if you have your PETG settings dialed it will probably turn out fine. I strongly recommend printing in PETG, as these machines get quite warm especially if there are other devices/computers in the vicinity.