H2D Flushing Chute | H2D Poop Chute

Calibration running on the H2D i sat down opened F360 and started drawing out what I wanted in a poop chute.  This flush chute stands away from the vents on the back of the printer and provides a fun travel to a removable drawer that has a lid with a hinge that uses raw filament at the pin.  Have fun with this and most prints without support.  The PDF in the documentation section has assembly pictures, instructions, and many tips and tricks for any questions you may have. 

Please make sure to look at the documentation for the PDF assembly guide/help

** There is an alternative tower if you prefer the round vs the angular arches.   if you print the alternate tower that have round arches you should enable tree supports. it is behind the printer and it did print ok 5 out of 10 without supports.