Pickle Rick 4-Piece High Performance Coaster Set

This is a 4-piece coaster set featuring pickle rick as the coaster holder.  Pickle rick face on both sides.  The coaster holder prints in 3 pieces for a faster print.  The rick face is only a few layers deep and then shifts to all green.  The parts assemble basically without glue but a few drops is recommended. (Note on assembly - if the pickle rick ends don't line up perfectly on the base part, just swap the sides and it will fit fine).

ULTIMATE COASTER

This is not your regular run of the mill Makerworld coaster. This one is a 2-piece design that does not require an AMS for the multi-color design, and it's got features that your typical flat coaster does not have.

1) This coaster is extra-large to accommodate most large steins or over-sized mugs. At 5” in diameter, you can even fit your cereal bowl on it (probably).

2) The slatted design of the top allows condensation or drips on the glass to seep through into the coaster. No more cold condensation drips off your glass and onto your shirt!

3) The slats have weep holes formed through them to help wick moisture down into the surrounding collection moat.
 

4) The slats have rounded top edges for minimal contact to your glass to make sure it doesn’t suction up when you lift your glass.
 

5) The lower portion of the coaster is domed to allow accumulated liquid to fall into the surrounding collection moat.

The two parts simply fit together and can be separated to wash although it's not really necessary. A quick rinse under the faucet does the trick. I have had one on my desk for years and it has worked great, especially in the summer when the humidity is up.