Search models, users, collections, and posts
Collapsible Deck Holder
IP Report
Print Profile(2)
0.16mm layer, 2 walls, 15% infill
Designer
3.2 h
2 plates
0.16mm layer, 2 walls, 15% infill
2.9 h
2 plates
Open in Bambu Studio
Boost
60
177
20
4
130
69
Released
Description
This deck holder can hold standard size cards stacked up to 94mm tall. The spokes can be taken apart and slotted inside the base, allowing for a smaller storage footprint.
Plate 1 contains the base, it has to be printed in this weird 45 degree angle to avoid difficult-to-remove supports, it is thus prone to falling over during printing. Using CoolTack plates or glue is strongly recommanded. Plate 2 contains the 2 spokes, they are the same model but mirrored.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (20)