Search models, users, collections, and posts
4" Duct Cuff
IP Report
Print Profile(1)
0.2mm layer, 1 wall (vase mode), 0% infill
Designer
24 min
1 plate
Open in Bambu Studio
Boost
0
3
0
0
0
0
Released
Description
I needed a cuff to help connect this Dryer Vent Window Kit to this 4" to 3" reducer for venting our new XTool S1 laser cutter. I created this simple cuff using vase mode (it's stronger than I was expecting for a single wall), then taped the pieces together with duct tape.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)