Search models, users, collections, and posts
Speaker Riser/Stand with Storage Compartment
IP Report
Print Profile(1)
0.8mm nozzle, 0.56mm layer, 3 walls, 12% infill
Designer
18.9 h
3 plates
Open in Bambu Studio
Boost
30
75
1
4
90
15
Released
Description
This is a pair of riser stands for 5 inch speakers. I have only tested these on KRK Rokit5 speakers.
I printed these in EL EGOO Rapid PETG. They have little feet for traction that is printed with Bambu 90a TPU. The feet should be optional and could be replaced with other non printed parts.
The larger of the two risers is a cube, designed to store a KOMPLETE Audio 2 audio interface. This took 9 hours to print.
The smaller, tapered riser is also capable of storage. This took 8 hours to print.
Both risers are the same height (130 mm)
Both were printed with a 0.8 mm nozzle at 0.56 mm layer height for strength and speed.
These models were designed in Plasticity.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (1)