Search models, users, collections, and posts
Unbound Angel
IP Report
Print Profile(1)
0.2mm nozzle, 0.08mm layer, 4 walls, 15% infill
Designer
10.3 h
1 plate
Open in Bambu Studio
Boost
22
48
0
0
17
3
Released
Description
⚠️ IMPORTANT PRINTING NOTES – READ BEFORE PRINTING
🔧 Supports Required – This model absolutely requires supports due to the extended wings and complex geometry.
- 📏 Layer Height Matters – You must print at 0.08mm or finer. Printing at 0.2mm will result in wing detail being cut off or missed entirely.
- ✅ Side-by-side comparison image included (0.08mm vs. 0.2mm)
- 🕊 Fragile Wings – The wing structures are delicate and may snap if handled roughly post-print. Take extra care when removing supports and during transport.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)