LTT Screw Driver Holder + 40 bits with Extension - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

Heath

Tools>Other Tools

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 3 walls, 15% infill

Designer

4.2 h

1 plate

5.0(10)

Open in Bambu Studio

Boost

117

Released

Description

Updated - I have finally received my extension bit and the slot is 10mm longer than the description they provided.

Pretty simple build.

3 Wall

15% infil gyroid

Comment & Rating (17)

@Aegisnir

Boosted

Print Profile

0.2mm layer, 3 walls, 15% infill

was concerned that PETG or PLA might damage the surface of the screwdriver so I printed in Bambu white TPU. came out near perfect. not a single issue. no cleanup needed.

The profile uploader has replied

@hfoster52

That's a great idea. Thank you for sharing.

@JustKuz

Where is the file for the insert? I would also like to print in TPU but the original file seems to be missing the internals.

@JZDABOSS

Printed in PLA, fits perfectly in the box. The part holding the screwdriver handle is also a bit tight, over time it may cause some rubbing wear on the plastic handle. Maybe in your future revisions, could give a bit more width to the screwdriver handle as well.

@JZDABOSS

Just finished printing this along with the box. The box is overall pretty good, nothing to complain, for the holder, the bit holes are quite tight, and most of the bits i cannot push all the way in and is a struggle to remove the first few times. After a few insert/removals it fit better. Also, the spacing between the bits seem a bit too tight, there's actually quite a bit of space between the bits and the handle, would've preferred if each bit had a bit more space around it to grab using the fingers. As a side request, it would be cool if you could design a model that has the bits fit a bit looser but allow magnets to be added below the bit holders to hold the bits in by magnets.

The designer has replied

@hfoster52

I can do that. I kept them tight so they would grip. But I like your magnet idea. I have seen it on other holders. I will definitely put another revision. thank you

@FusedStamen

Replying to @hfoster52 :

i just printed this and i think if you come back around to it, adding a pause to insert 6x2mm magnets before the last could layers in the bit holder would be amazing. i haven't learned enough to figure that out yet lol