Fork Bike Rack 70mm High 10mm Axle
Print Profile(1)
Description
Rack for securing the bicycle fork during transport. Simply remove the front wheel and clamp the fork of the bicycle to the holder, and you're done.
The holder is suitable for forks with a width of 100mm and an axle diameter of 10mm.
The height from the base to the bottom of the axle is 70mm.
- Print plate 1: with an 8mm wide bridge for 40mm aluminum profiles (Item, Bosch,…)
- Print plate 2: without bridge, to screw the holder onto a plate
Two M8 screws and matching washers are also required to mount the holder. In addition, two M10 nuts and two M10 screws are needed for clamping. I found the knurled knobs here:
https://makerworld.com/en/models/938681-knurled-screw-and-knurled-nut-for-m5-m10#profileId-905841
I think these fit very well. The length of the screws depends on the width of the fork.
Boost Me (for free)
I would be very happy about a boost.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (9)