Search models, users, collections, and posts
Avatar Moonlight mount for GEPRC cinelog30 v2
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
54 min
1 plate
Open in Bambu Studio
Boost
6
9
0
0
22
7
Released
Description
This print allows to mount Walksnail Avatar Moonlight to GEPRC cinelog30v2.
Standart VTX place too small for Moonlight.
I did remove Gopro mount and place my model instead.
For big mount holes i did “washers” that should be from bottom side of drone plate.
I did use additionaly:
- embedded nuts for m3 screws (4mm outer diameter and 4mm height)
- m3 screws 9mm (looks like shorter is better)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)