Search models, users, collections, and posts
Omp M1 Evo Esc Protective case
IP Report
Print Profile(1)
0.2mm layer, 100% infill, 0.4 nozzle, Printed on P1S
Designer
51 min
1 plate
Open in Bambu Studio
Boost
3
7
0
0
2
1
Released
Description
M1 evo duel esc protective case, sick of breaking back of esc and having to replace, this case uses same screw holes and just sit esc in there and zip tie over lid and around bottom of battery. printed 100% TPE or PETG no supports. TPE prints easy and is flexible and can handle impacts. havn't fully tested but so far so good. do not screw esc down just sit it in there. printed my own canopy out of TPE to suit. Motor wires must be extended.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)