Search models, users, collections, and posts
This model is created by Image to Keychain
Make Your Model
Print Profile(1)
0.16mm layer, 4 walls, 30% infill
Designer
1.9 h
1 plate
Open in Bambu Studio
Boost
12
32
5
3
82
57
Released
Description
This is a custom 3D-printed phone base designed specifically for the Anker 313 Magnetic Charger. It provides a stable, angled stand for convenient viewing or standby-mode while charging. Compatible with iPhones and other MagSafe-enabled devices, the base securely holds the charger and keeps your setup clean and organized.
Boost Me (for free)
Assembly:
Just push the USB-C end of the charger from the top towards the bottom of the base and route the cable on the indent on the bottom side of the base. You could use some tape to secure the cable if it is flexing out.
After the cable is through, push the front side of the charger towards the front of the base. The charger is press-fitted with the base.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (5)