Search models, users, collections, and posts
Triangle pinko board
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.2 h
3 plates
Open in Bambu Studio
Boost
16
23
0
0
21
16
Released
Description
It is used by dropping a ball or a disk down it. Then I fell off the board. Then goes in a slot.
To assemble it, just put the pegs in the holes on the board. Some pegs are more prominent on one end than the other end.
It is made with normal pla fillment. You can customize the colors to your liking.
The process of how I created it was tough. At first, I created it to be way too small. Then, I added more rows to it.
License
This user content is licensed under a
Creative Commons Attribution-NoDerivatives
Comment & Rating (0)