Shelf Rail For Single and Double Monitor Shelf - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

RejectCode

Household>Office

IP Report

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

Designer

2 h

3 plates

4.9(11)

0.2mm layer, 2 walls, 15% infill

Designer

2.7 h

5 plates

5.0(4)

Open in Bambu Studio

Boost

127

Released

Description

I enjoyed these shelves by @GiskardReventlo but wanted to keep things from sliding off the back. In comes the rails that snap into the hex holes on the base of the shelf. I wanted a double wide shelf with a rail as well so created one in two pieces that snap together and then into the bases of two shelves next to each other. I didn't see the multi-shelf connectors by @deigge until I had already made my own but either should work to keep the shelves together.

shelf

shelf clip

rail

Comment & Rating (25)

@metus88

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Perfect! I will give you my boost! Only one advice to other makers: consider the thickness of your screen frame before clip it. I did a little mistake at the beginning but they are easy to remove and put it where they can stay. Thanks

The profile uploader has replied

@user_2861899726

Looks good. Glad it printed well for you and hope it keeps all your things from sliding off the back :) I also snapped the rails together and didn't leave enough space when I made them but as you said, it's easy to pull them back off or push them out from the top side.

@GregO83

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Perfect! So useful!

The profile uploader has replied

Show original

@user_2861899726

Looks good, glad you like it!

@Novice1

Print Profile

0.2mm layer, 2 walls, 15% infill

Great addition to my monitor shelf. Thank you!

@Novice1

Print Profile

0.2mm layer, 2 walls, 15% infill

Love this shelf. The modular design is nice so you can set it up to suit your needs. It was an easy print and well designed!

@Zhobi

Print Profile

0.2mm layer, 2 walls, 15% infill

With this you can make it as long as you want :)

@Zhobi

Print Profile

0.2mm layer, 2 walls, 15% infill

Very functional.

@Sprout

Thanks 👍

@RolfHahil

Hey, Im glad that I had looked again for @GiskardReventlo 's design and found your remix. I would love to print it, but Im planing to stack three shelfs next to each other. Sadly you dont yet have a "straight" backrail. Would you please consider creating one? :) Thanks!

The designer has replied