Search models, users, collections, and posts
Seal for XJ-11401C1
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
18 min
1 plate
Open in Bambu Studio
Boost
1
0
0
0
1
2
Released
Description
My wife got a Thinkkitchen “magic bullet” alike mixer and the seal failed after 10 years and nothing available because it is not an official magic bullet and the size are not the same. So I designed a seal and printed out in TPE 80A, very soft. Made some test in PLA to have an exact drop-in part and printed in TPE 80A right away. Low and SLOW, 50mm sec, anyway, took 12 minutes on my X1C. DO NOT USE AMS. The included profile is for X1C and it slowed down to 50mm/sec. It should work with TPU 90A too but not tested, I wanted mine soffffftttttt :)
Hit me up if the design save your couple and your thinkkitchen/bella bullet mixer ;)
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)