Big Brick * Baseball

5/2026: NEW PRINT PROFILE WITH INCREASED SUPPORTS - V2

A few people mentioned that they had some issues with the supports falling off halfway through this multi-color print which is frustrating and wastes a lot of time and money. I increased the supports and changed them from tree to normal supports so there is less of a chance of support failure.  The supports still remove easily. As with version one, there is still a lot of filament waste because of the multiple color changes. Make sure you have enough filament before you print!

This is a Baseball accessory for baseball-related Big Brick Figures. 

Handle should fit most Big Bricks (approx 6:1, 500%) on Maker World, but make sure to check sizing prior to printing. Handle diameter is ~16.5 mm.

AMS is required. 

Be prepared - this baseball creates A LOT of filament poop (see photo - I printed 4 baseballs at one time). There is some minor bleeding because of the red on white as well. 

Minor support is needed for the baseball's bottom.

I made a separate handle so you can print it separately and screw it on and off. A support blocker was placed on the screws parts/threads.  You may get stringing due to this, but just screw in the handle and it'll take those away. You may need to clean up the threads a bit if the screw handle doesn't engage.

Printed at 7% Lightning which works fine, but if you want more durability, I would do at least 10% and your infill of choice.

This is the basketball version.

If you’re looking for different faces, check out my collection of Big Brick Faces!

For the different hairstyles:

• Female brick ponytail
• If you're looking for other hairstyles, check out my collection of Big Brick Hair!