8898 soldering station (temu) mounting brackets

the only and best mounting brackets for 8988 soldering station.

how to use it

1. remove rubbers underneath the soldering station
2. remove the screw
3. put the bracket on top of the hole, so it goes around the lip where the rubbers were prior.
4. optionally put a little superglue on the bit that goes over the lip for extra strength.
5. screw the original screw back in with the bracket applied. note: the hole might be slightly too small for it to go in far enough. in which case youd need to e.g. heat up the screw and push it in to melt the plastic a bit with the screw head. the screw needs to properly reach the thread inside of the soldering station so be sure its in.
6. do so on all 4 corners.
7. use a fitting screw to mount it on your wall or wherever. the hole is 3 mm but you can just heck a bigger one through it if you'd want.